Show the schematic of a LUT (using a multiplexer0 which implements the logic for a 3-input AND gate.

For an eight-bit D/A converter having a range of 5 V, convert 10110110 into an analog sample value (consider using the mathematical method – Hint: convert to decimal and multiply by step size).

The given converterhas the following requirements: Vin: 250V 50V regulated Load power: 200W Switching frequency: 100kHz Max. output ripple: 20mV Vout: A Q1 L G1 1 L1 Vin Q2 Vn C1 Vout G2 (a) Differentiate the difference and advantage of the synchronous buck converter with a typical buck converter circuit. 15

Q2) How can use one pin for input and output data without conflict in FPGA; explain that with using the figure.

Please answer fast I'll rate

A 3.29-V signal is input to a 12-bit successive approximations converter with an inputrange of 0 to 10 V and simple binary output. Simulate the successive-approximationsprocess to determine the simple binary output.

Draw a common gate amplifier and common source label input and output and state difference?

Design and simulate a power supply that is able to take 120 Vrms input signal and deliver a nominal 5VDC output at 25mA with ~1% ripple at the rectifier.

Give at least 3 applications (with circuit) of SCR and explain the operation of SCR in every application.