Compare the behavior of the 7408 2-input AND gate with that of the 7400 2-input NAND gate. In what way do they behave similarly? In what way are they different?

tetake question VG1 Answer VDD 3Vdc Bout ↓ M1 Rload Vout CMOSN The n-MOSFET current source in Figure 1 (also known as the current sink) operates with a fixed gate-to-source DC voltage VG1. The MOSFET design parameters are W=30 um and L= 0.5 um. The voltage drop across the load Vout can vary due change of load resistance however the MOSFET always operates in the saturation mode: Vout is greater than the overdrive voltage. Estimate the value of the bias voltage VG1 in Volts required for the current source value of 50 uA. Assume that n-MOSFET is an enhancement-mode device fabricated with the standard process parameters: Vtn = 0.7V, kn' =200 uA/V2. Neglect the Early effect on the drain current. Your Answer:

(b) List the steps needed to test any four-terminal MOSFET with the same setup to determine which terminal is the gate, which terminal is the body, whether the device is a N-channel or P-channelMOSFET, and whether the device is a D-mode or an E-mode.

Problem 9. Suppose you have an NMOS transistor with a threshold voltage of 1 V. You apply 3 V to the gate, ground the body and source, and apply +5 V to the drain electrode. Do you expect this transistor to work properly?

(b) List the steps needed to test any four-terminal MOSFET with the same setup to determine which terminal is the gate, which terminal is the body, whether the device is a N-cha (c) If the gate oxide were destroyed by a static electricity discharge, speculate on how the current readings might be different from those that were observed.Be detailed in your response.

i need detail explanations on how to solve this question

An n-channel JFET is biased such that VGS = –2 V using self-bias. The gate resistor is connected to ground. What is VS? What is the value of VGS(off) if VP is specified to be 6 V?

Which input must be active for a BCD priority encoder for its active-HIGH outputs to have the following code: a. Q3Q2Q1Q0 = 0111 b. Q3Q2Q10 = 0001 C. Q3022Q1Q0 = 1001 d. Q3Q2Q1Q0 = 0000

Draw a common gate amplifier and common source label input and output and state difference?