• # quelques infos en plus alors

    Posté par . En réponse au message Besoin d'ajouter le support d'iptables dans une distribution un peu.. spéciale !. Évalué à 1.

    quelques infos en plus alors
    CurrentFirmwareDesc : "MyBookLive " "02.11.09-053" "Core F/W" "1334341296" "1338507958"

    ~# cat /proc/cpuinfo
    > processor : 0
    cpu : APM82181
    clock : 800.000008MHz
    revision : 28.130 (pvr 12c4 1c82)
    bogomips : 1600.00
    timebase : 800000008
    platform : PowerPC 44x Platform
    model : amcc,apollo3g
    Memory : 256 MB

    dmesg
    cross:500608k
    svc: failed to register lockdv1 RPC service (errno 97).
    Calling ledset_blink with value x
    eth0: link is up, 1000 FDX, pause enabled
    eth0: no IPv6 routers present
    eth0: link is up, 1000 FDX, pause enabled
    eth0: no IPv6 routers present
    device eth0 entered promiscuous mode
    device eth0 left promiscuous mode
    eth0: link is up, 1000 FDX, pause enabled
    eth0: no IPv6 routers present
    md: md0 stopped.
    md: unbind
    md: export_rdev(sda2)
    md: cannot remove active disk sda1 from md1 …
    md: bind
    RAID1 conf printout:
    --- wd:1 rd:2
    disk 0, wo:0, o:1, dev:sda1
    disk 1, wo:1, o:1, dev:sda2
    md: recovery of RAID array md1
    md: minimum _guaranteed     speed: 1000 KB/sec/disk.
    md: using maximum available idle IO bandwidth (but not more than 200000 KB/sec) for recovery.
    md: using 2048k window, over a total of 1999808 blocks.
    md: md1: recovery done.
    RAID1 conf printout:
    --- wd:2 rd:2
    disk 0, wo:0, o:1, dev:sda1
    disk 1, wo:0, o:1, dev:sda2