Oooops I meant with Ham V you get DCU-1 ... SRI At 01:26 PM 4/14/2005, Al Bailey wrote: >Ham IV and Ham V are exact same rotor BUT with Ham IV you get the DCU-1 >controller... >>>>>>At 01:20 PM 4/14/2005, Jack wrote: >>I am unfamiliar with there being a Hygain HAM V. I know that there was a >>Ham IV and also a Tx2. In any case, the answer of whether a rotor would >>work with software control from DXbase would depend upon the rotor >>control box's ability to support RS232 interface, and whether the >>commands required could be set up in DXbase user options. Or possibly >>the rotor emulates the commands of some other existing rotor and could >>therefore use that. >>>>Regards, >>Jack >>>>----- Original Message ----- From: "JNMazzoni" <JNmazzoni at comcast.net> >>To: <dxbase at mailman.qth.net> >>Sent: Thursday, April 14, 2005 11:28 AM >>Subject: [Dxbase] Rotor Interface >>>>>>Is dxbase 2005 compatable with hy-gain's HAM-V rotator? >>______________________________________________________________ >>Dxbase mailing list >>Home: http://mailman.qth.net/mailman/listinfo/dxbase >>Help: http://mailman.qth.net/mmfaq.htm >>Post: mailto:Dxbase at mailman.qth.net >>>>______________________________________________________________ >>Dxbase mailing list >>Home: http://mailman.qth.net/mailman/listinfo/dxbase >>Help: http://mailman.qth.net/mmfaq.htm >>Post: mailto:Dxbase at mailman.qth.net >>>>______________________________________________________________ >Dxbase mailing list >Home: http://mailman.qth.net/mailman/listinfo/dxbase >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:Dxbase at mailman.qth.net