Ham IV and Ham V are exact same rotor BUT with Ham IV you get the DCU-1 controller... At 01:20 PM 4/14/2005, Jack wrote: >I am unfamiliar with there being a Hygain HAM V. I know that there was a >Ham IV and also a Tx2. In any case, the answer of whether a rotor would >work with software control from DXbase would depend upon the rotor control >box's ability to support RS232 interface, and whether the commands >required could be set up in DXbase user options. Or possibly the rotor >emulates the commands of some other existing rotor and could therefore use >that. >>Regards, >Jack >>----- Original Message ----- From: "JNMazzoni" <JNmazzoni at comcast.net> >To: <dxbase at mailman.qth.net> >Sent: Thursday, April 14, 2005 11:28 AM >Subject: [Dxbase] Rotor Interface >>>Is dxbase 2005 compatable with hy-gain's HAM-V rotator? >______________________________________________________________ >Dxbase mailing list >Home: http://mailman.qth.net/mailman/listinfo/dxbase >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:Dxbase at mailman.qth.net >>______________________________________________________________ >Dxbase mailing list >Home: http://mailman.qth.net/mailman/listinfo/dxbase >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:Dxbase at mailman.qth.net