[DXBase] controlling Icom 706MKIIG
Tony Cash
[email protected]
2002年11月17日 02:10:15 -0500
----- Original Message -----
From: "Jack" <[email protected]>
To: <[email protected]>; <[email protected]>
Sent: Saturday, November 16, 2002 6:07 PM
Subject: Re: [DXBase] controlling Icom 706MKIIG
> Most early ICOMs used 1200, 8, N, 1 but since some of these settings can
be
> modified within the radio, you will probably need to confirm what your
> particular radio is set for. Also, some of these radios have autobaud
> detect option. Don't use this, but instead, set a specific baud rate and
> then set DXbase to agree with what you have set in the radio.
>> Regards,
> Courtney
>> ----- Original Message -----
> From: <[email protected]>
> To: <[email protected]>
> Sent: Saturday, November 16, 2002 1:33 PM
> Subject: [DXBase] controlling Icom 706MKIIG
>>> > Has anyone had any success controlling an Icom 706MKIIG from DXBase. If
so
> can
> > you please tell me what settings you used (baud rate, parity, bit, and
> stop
> > bit)?
> >
> > Thanks
> > _______________________________________________
> > DXBase Reflector - Please visit us on the web at www.dxbase.com
> > - - - - - - - - - - - - - - - - - - - - - - -
> > To UNSUBSCRIBE please visit:
> > http://mailman.qth.net/mailman/listinfo/dxbase
> >
>>> _______________________________________________
> DXBase Reflector - Please visit us on the web at www.dxbase.com
> - - - - - - - - - - - - - - - - - - - - - - -
> To UNSUBSCRIBE please visit:
> http://mailman.qth.net/mailman/listinfo/dxbase
>