[DXBase] controlling Icom 706MKIIG
Jack
[email protected]
2002年11月16日 18:07:57 -0500
Most early ICOMs used 1200, 8, N, 1 but since some of these settings can be
modified within the radio, you will probably need to confirm what your
particular radio is set for. Also, some of these radios have autobaud
detect option. Don't use this, but instead, set a specific baud rate and
then set DXbase to agree with what you have set in the radio.
Regards,
Courtney
----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Saturday, November 16, 2002 1:33 PM
Subject: [DXBase] controlling Icom 706MKIIG
> Has anyone had any success controlling an Icom 706MKIIG from DXBase. If so
can
> you please tell me what settings you used (baud rate, parity, bit, and
stop
> bit)?
>> Thanks
> _______________________________________________
> DXBase Reflector - Please visit us on the web at www.dxbase.com
> - - - - - - - - - - - - - - - - - - - - - - -
> To UNSUBSCRIBE please visit:
> http://mailman.qth.net/mailman/listinfo/dxbase
>