- HOME
- Test Systems
- Material Fatigue Test Systems
- DMH Thermal Fatigue Test System
DMH Thermal Fatigue Test System
Thermal Fatigue Test System
-
DMH Thermal Fatigue Test System
DMH Thermal Fatigue Test System
This test system is designed to synchronize both repetitive stresses with a hydraulic servo system and temperature cycling with a high-frequency induction heating system to control the degree of constraint during thermal cycles.
DMH250 Thermal Fatigue Test System High-frequency induction heating system
| Temperature range | 300°C to 1200°C |
|---|---|
| Heating system | High-frequency induction heating system (Direct and indirect induction heating) |
| Control system | Heat cycle and temperature constant control by PID control |
| Heating speed | Approx. 70s from room temperature to 1000°C |
| Cooling system | Air servo system (Simultaneous control of heating and cooling by PID control) |
| Cooling speed | Approx. 60s from 1000°C to 300°C |
| Temperature distribution | Within 15°C (GL-15mm at 900°C) |
| Attainable vacuum | 10-3Pa order (by constant heating at 900°C) |
| Pumping speed | Approx. 40min. up to 10-3 Pa order |
| Vacuum pump | Turbo molecular pump and oil rotary pump |
| Vacuum gauge | Pirani gauge and ionization gauge |
| Power supply | 3-phase 200V, 3kVA |
| Cooling water | 25L/min at 30°C |
Material Fatigue Test Systems
- SMH Material Fatigue Test System
- BMH Large-sized Material Fatigue Test System
- EMH Environment Test System
- DMH Thermal Fatigue Test System
- CMH Bi-axial Material Test System
- FMH Ultra High-Cycle Test System
- GMH High-Speed Material Test System
- HMH Load Sensing Block Type Material Test System
- IMH Hot Process Simulator
- JMH Ultra Low-Temperature Fatigue Test System
- KMH Corrosion Fatigue Test System
- LMH Micro Load Test System
- MMH Multi-Axis Material Test System
- NMH Wear Test System
- HOME
- Test Systems
- Material Fatigue Test Systems
- DMH Thermal Fatigue Test System