[Logic] Packet Cluster
Bradford J. Williams - N8GLS
[email protected]
2002年4月16日 21:03:01 -0400
Hi Denis,
Do a sanity check to see that you have set-up the TNC by going to the main
toolbar and select "Tools", then "Set-up", then "Misc Ham Set-up". Your TNC
should be configured under the "Data Terminal" tab. Not to be confused with
the Log Form window set-up.
If the above was configured okay, and you still have no communication,
verify again for yourself that you have the correct com port and parameters
set-up, i.e., baud, data bits and parity for the TNC, PC com port and LOGic.
You probably already went through this, but, never hurts to check again
before you go deep into another troubleshooting routine.
73,
Brad, N8GLS
-----Original Message-----
From: [email protected] [mailto:[email protected]]On
Behalf Of EI6HB
Sent: Tuesday, 16 April, 2002 1:39 PM
To: [email protected]
Subject: [Logic] Packet Cluster
Hi All,
Got Logic6 up and running - one problem I seem to have is getting
Logic6 to 'see' my PK232 TNC for cluster. Had it on com 1 in Logic5 and had
no problems. Have checked the com ports etc and seem to be working - even
switched the rig control to com 1 to make sure and that works ok.
any ideas on what I should do next would be appreciated
de Denis EI6HB
_______________________________________________
LOGic mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/logic