[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
Trying to Install Debian Sarge via net install (via CD) on a dell power edge 6350. The power edge has a PERC2/SC raid controller in it, with 3 8.5 Gig drives. I have the raid controller setup to do mirroring on two of the drives with one as a hot spare.
That *seems* to be set up correctly, formatted the disks, created the array, set to RAID 1, and then initialized the logical device. Rebooted, with the Debian cd. I then proceed to attempt to install Debian, which works well until it tries to find the hard disk so it can partition. It cannot.
I understand the perc2/sc uses the megaraid module, which I loaded by hand after the attempt to partition failed. I then attempted this step in the install again, no change. I tried various little things I found online, nothing seems to work. I am sort of at a loss here as to what to do next.
If anyone has any suggestions I would be happy to hear them. :) -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.4 (GNU/Linux)
iD8DBQFBx6bI3IzKSZsd6+oRAhUgAJ4o3glmpMnTa0ux9d56tHDbUvlHpwCeMjUY AWKzntqz5auVTayVf8dfKXY= =5pHZ -----END PGP SIGNATURE----- ___________________________________________________________________________ Philadelphia Linux Users Group -- http://www.phillylinux.org Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce General Discussion -- http://lists.phillylinux.org/mailman/listinfo/plug