1
\$\begingroup\$

I'm trying to run two fans when there is a call for heat but I want fan 2 to shut off a few minutes later. I don't have an off delay timer however I do have an on-delay timer and a relay. I know it can work I just can't seem to figure it out.

Hearth
45.6k7 gold badges80 silver badges184 bronze badges
asked May 4, 2020 at 18:35
\$\endgroup\$
2
  • 1
    \$\begingroup\$ (1) Mains? (2) Is the on-off switch a double-throw type (NO and NC contact)? (3) Is the timer NO, NC or changeover? Hit the edit link. \$\endgroup\$ Commented May 4, 2020 at 19:16
  • \$\begingroup\$ There's no need to edit the title after it's solved. Marking an answer as accepted marks the question as solved. \$\endgroup\$ Commented May 6, 2020 at 22:14

1 Answer 1

0
\$\begingroup\$

schematic

simulate this circuit – Schematic created using CircuitLab

Figure 1. Timing diagram and circuit schematic.

How it works:

  • TIMER1 is normally energised but when power is first switched on at the mains FAN2 will run until the timer times out.
  • When SW1 is closed FAN1 will run, RLY1 will be energised and power off TIMER closing its NC contact causing FAN2 to run.
  • When SW1 is opened FAN1 will switch off and RLY1 will drop out.
  • TIMER will begin timing and when the set time has elapsed the TIMER contact will switch to the NO position switching off FAN2.

This pre-supposes that both the relay and timer have changeover contacts (but you gave no details or datasheet links).

answered May 4, 2020 at 19:38
\$\endgroup\$
3
  • \$\begingroup\$ Nope, This is exactly what I have! I apologize for the vagueness because I wasn't sure at first either. \$\endgroup\$ Commented May 5, 2020 at 19:11
  • \$\begingroup\$ Good. If it works then please accept the answer to indicate that it has been solved. \$\endgroup\$ Commented May 5, 2020 at 19:31
  • \$\begingroup\$ @Bigpaa: The "accept" button is located with the up/downvote buttons. When you accept the answer is marked in green on this page and the question is marked in green on the questions index. No need for "[solved]" in the title. \$\endgroup\$ Commented May 7, 2020 at 6:18

Your Answer

Draft saved
Draft discarded

Sign up or log in

Sign up using Google
Sign up using Email and Password

Post as a guest

Required, but never shown

Post as a guest

Required, but never shown

By clicking "Post Your Answer", you agree to our terms of service and acknowledge you have read our privacy policy.

Start asking to get answers

Find the answer to your question by asking.

Ask question

Explore related questions

See similar questions with these tags.