netboot e100/d101m_ucode.bin not found
| Affects | Status | Importance | Assigned to | Milestone | |
|---|---|---|---|---|---|
| linux (Ubuntu) |
Fix Released
|
Medium
|
Tim Gardner | ||
Bug Description
Using both karmic and jaunty netboot images from:
http://
installed karmic from cd,
box can pxe boots,
I am getting "E100_request_
(10:03:28 AM) cjwatson: CarlFK: I *think* that's the responsibility of the kernel to ship the right bits in the firmware udebs
(10:05:02 AM) CarlFK: cjwatson: isn't the installer kernel the same as the kernel that gets installed? (so should have all the same support... so something broke)
(10:05:32 AM) cjwatson: CarlFK: the kernel image (vmlinuz) itself is, but the module selection is stripped down
(10:05:36 AM) cjwatson: (and always has been)
(10:07:49 AM) CarlFK: cjwatson: ok - as long as its intentional and not an opps. but I am guessing good nic support is something the netboot kernel should have - Ill bug all this and let someone make a decision
(10:08:15 AM) cjwatson: stick the bug on linux, it's probably just a matter of adding that file to nic-firmware
carl@obiz1:~$ lspci
00:00.0 Host bridge: Broadcom CNB20LE Host Bridge (rev 05)
00:00.1 Host bridge: Broadcom CNB20LE Host Bridge (rev 05)
00:01.0 RAID bus controller: LSI Logic / Symbios Logic 53C1510 (rev 02)
00:03.0 VGA compatible controller: ATI Technologies Inc 3D Rage IIC 215IIC [Mach64 GT IIC] (rev 7a)
00:04.0 System peripheral: Compaq Computer Corporation Advanced System Management Controller
00:0f.0 ISA bridge: Broadcom OSB4 South Bridge (rev 4f)
00:0f.1 IDE interface: Broadcom OSB4 IDE Controller
03:04.0 Ethernet controller: Intel Corporation 82557/8/9/0/1 Ethernet Pro 100 (rev 08)
03:05.0 Ethernet controller: Intel Corporation 82557/8/9/0/1 Ethernet Pro 100 (rev 08)
Installs fine from CD, nic works.
This bug was fixed in the package linux - 2.6.31-12.39
---------------
linux (2.6.31-12.39) karmic; urgency=low
[ Andy Whitcroft ]
* install the full changelog with the binary package
* changelog -- explicitly note rebases and clean history
[ Tim Gardner ]
* Revert "SAUCE: (drop after 2.6.31) Disable iwl-1000 series wireless
adapters"
* Revert "SAUCE: (drop after 2.6.31) eCryptfs: Prevent lower dentry from
going negative during unlink"
* Revert "SAUCE: (drop after 2.6.31) em28xx: ir-kbd-i2c init data needs a
persistent object"
* Revert "SAUCE: (drop after 2.6.31) saa7134: ir-kbd-i2c init data needs
a persistent object"
* Revert "drm/i915: Check that the relocation points to within the
target"
* Revert "drm/i915: fix tiling on IGDNG"
* Revert "Driver core: add new device to bus's list before probing"
* Revert "HID: completely remove apple mightymouse from blacklist"
* Revert "KVM: x86: check for cr3 validity in ioctl_set_sregs"
All reverts superseded by corresponding v2.6.31.2 patches
* [Config] Add d101m_ucode.bin to d-i/firmware/
- LP: #439456
* [Config] Enabled CONFIG_
- LP: #443117
* [Config] Add cpio as a build dependency.
* [Config] Set default I/O scheduler back to CFQ for desktop flavours
- LP: #381300
[ Upstream Kernel Changes ]
* KVM: VMX: Fix EPT with WP bit change during paging
* pata_amd: do not filter out valid modes in nv_mode_filter
* p54usb: add Zcomax XG-705A usbid
* x86: Increase MIN_GAP to include randomized stack
* serial: bfin_5xx: fix building as module when early printk is enabled
* USB: option.c Add support for ZTE AC2726 EVDO modem
* USB: option: TELIT UC864G support
* video: s3c_fb.c: fix build with CONFIG_HOTPLUG=n
* kbuild: fix cc1 options check to ensure we do not use -fPIC when
compiling
* drivers/
* thinkpad-acpi: don't ask about brightness_mode for fw. 1V and 1R
* ACPI: pci_slot.ko wants a 64-bit _SUN
* fbcon: only unbind from console if successfully registered
* kallsyms: fix segfault in prefix_
* sisfb: change SiS_DDC_Port type to SISIOADDRESS
* mmc_spi: fail gracefully if host or card do not support the switch
command
* alpha: AGP update (fixes compile failure)
* fs: make sure data stored into inode is properly seen before unlocking
new inode
* eCryptfs: Handle unrecognized tag 3 cipher codes
* eCryptfs: Check for O_RDONLY lower inodes when opening lower files
* eCryptfs: Filename encryption only supports password auth tokens
* eCryptfs: Validate global auth tok keys
* eCryptfs: Prevent lower dentry from going negative during unlink
* Re-enable Lanman security
* xen: make -fstack-protector work under Xen
* xen: only enable interrupts while actually blocking for spinlock
* xen: use stronger barrier after unlocking lock
* xen: check EFER for NX before setting up GDT mapping
* perf_counter: Fix perf_copy_attr() pointer arithmetic
* perf tools: Fix buffer allocation
* tty: serial/pcmcia: add ID for Advantech card
* PM / PCMCIA: Drop second argument of pcmcia_