Arduino sells a holder for the UNO board, but without much documentation or detailed specifications, see this link. Can anyone give the diameter of four small holes, two located on the top edge and one each on the left/right edges? What size of screw will fit? They are smaller than M3 / 4-40 apparently.
Also, does anyone know what material is the holder made from?
-
1If you can read the recycle logo on the plastic, you should be able to determine the material. The image is too unclear to determine from the post.fred_dot_u– fred_dot_u2019年04月12日 01:21:29 +00:00Commented Apr 12, 2019 at 1:21
2 Answers 2
Arduino UNO holes are just over 3mm in diameter. Both 4-40 and M3 bolts will work well, giving you a bit of wiggle room. You will have to file down the width of the bolt head to fit against the 6 pin header near D13.
As far as the holder material, I don't know. I 3D print my own.
-
The holes I asked about are smaller than M3 (i.e. while on the Arduino PCB they may be M3, on the holder M3 screws are too large and do not fit), sounds like a design flaw.MichaelT– MichaelT2019年04月11日 23:00:36 +00:00Commented Apr 11, 2019 at 23:00
-
1Probably M2.5. The Arduino Uno is full of design flaws. Idiotic design "decisions" that normal people would never have made.Majenko– Majenko2019年04月12日 09:21:11 +00:00Commented Apr 12, 2019 at 9:21
** Self answer:
I obtained several of these holders from Arduino starter kits. They are made from a clear, colorless plastic that seems to have been injection molded. However, it is hard to tell exactly which plastic, since these does not have any recycle logo! The image posted in the original question is perhaps a newer version.
The four smaller holes can accept M2.5 screws, I checked.