5

I want to create a device that interfaces with the Light Strike Lasertag system using an Arduino Leonardo.

The Light Strike system uses not laser but regular infrared signals. According to a site that I found (http://www.meatandnetworking.com/projects/hacking-at-the-light-strike-laser-tag-game/) it uses 37.8 khz signals. I only found IR-receivers using 37.9 or 38 khz. Can I use them? How far can the modulation frequency differ?

Is there anything else I need to watch out for when creating an IR-interface?

asked Aug 2, 2015 at 11:16
1
  • 1
    That's more than close enough. See electronics.stackexchange.com/questions/84327/…. But note that the frequency being sent may vary from one gun to the next. So your may be different from the one that was tested in that article. Commented Aug 2, 2015 at 12:47

1 Answer 1

1

Can I use 37.9 or 38 kHz IR-receivers for 37.8 khz communication?

Yes you can, it should be close enough. (I am assuming you are talking about some kind of prebuilt receiver that just receives the IR data and transmits it via RS232 or something like that)

I'd suggest you'd use a phototransistor and a IR diode for the communication. You will have a lot more control over what frequencies you are operating on. Altho it might take a bit more work to program it, the end result will be exactly how you wish.

answered Aug 16, 2015 at 17:50

Your Answer

Draft saved
Draft discarded

Sign up or log in

Sign up using Google
Sign up using Email and Password

Post as a guest

Required, but never shown

Post as a guest

Required, but never shown

By clicking "Post Your Answer", you agree to our terms of service and acknowledge you have read our privacy policy.

Start asking to get answers

Find the answer to your question by asking.

Ask question

Explore related questions

See similar questions with these tags.