[LOGic] Logic 8 message

Sun Mar 23 08:10:28 EDT 2014

Happens to me all the time with my ICOM 7800. Don't know what the fix is.
Julio, W4HY
-----Original Message-----
From: logic-bounces at mailman.qth.net [mailto:logic-bounces at mailman.qth.net] On Behalf Of k1vc at cox.net
Sent: Saturday, March 22, 2014 10:10 PM
To: LOGic at mailman.qth.net
Subject: [LOGic] Logic 8 message
Hello All,
I run LOGic 8.0.104 with a Yaesu FT-1000D and FIF-232C CAT System. From the time I open LOGic until I close out of it, I get the following message:
Yaesu FT-1000 (com1)
A timeout occurred while attempting to communicate with a rig.
Make sure a rig is turned on and check cabling and setup parameters.
POLLING DISABLED. 0 characters in buffer.
In order to have the radio communicate with LOGic, I have to go to TOOLS > Reset radio and Rotor Interface.
I can be sitting in front of the radio just listening and the message will pop up and I lose communication with the radio and LOGic.
My parameters are:
Radio 1: FT 1000 (6.0 or later ROM)
Port: com1
Baud rate: Ø (should this be 4800?)
Stop Bits: 2
DTR and RTS both are checked.
Polling interval in seconds (polled rigs only): 2.0
Anyone experience the same problem?
Thanks,
Vin, 73
K1VC
______________________________________________________________
LOGic mailing list
Home: http://mailman.qth.net/mailman/listinfo/logic
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:LOGic at mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html