[LOGic] Logic 8 message

Sat Mar 22 22:56:47 EDT 2014

Vin, try using the Legacy drivers for you FT1000D. I had the same problem and used the Legacy driver for my IC765 and no more problem with resets, etc. 
Nick W9UM 
----- Original Message -----
Hello All, 
I run LOGic 8.0.104 with a Yaesu FT-1000D and FIF-232C CAT System. From the time I open LOGic until I close out of it, I get the following message: 
Yaesu FT-1000 (com1) 
A timeout occurred while attempting to communicate with a rig. 
Make sure a rig is turned on and check cabling and setup parameters. 
POLLING DISABLED. 0 characters in buffer. 
In order to have the radio communicate with LOGic, I have to go to TOOLS > Reset radio and Rotor Interface. 
I can be sitting in front of the radio just listening and the message will pop up and I lose communication with the radio and LOGic. 
My parameters are: 
Radio 1: FT 1000 (6.0 or later ROM) 
Port: com1 
Baud rate: Ø (should this be 4800?) 
Stop Bits: 2 
DTR and RTS both are checked. 
Polling interval in seconds (polled rigs only): 2.0 
Anyone experience the same problem? 
Thanks, 
Vin, 73 
K1VC 
______________________________________________________________ 
LOGic mailing list 
Home: http://mailman.qth.net/mailman/listinfo/logic 
Help: http://mailman.qth.net/mmfaq.htm 
Post: mailto:LOGic at mailman.qth.net 
This list hosted by: http://www.qsl.net 
Please help support this email list: http://www.qsl.net/donate.html