[Logic] Error in Logic 6.0

2002年4月20日 11:08:37 -0400

Hello Roland and ALL,
Yes as stated before and below I am experiencing the same issue. I also
had the same error message when importing the 1010.txt list. So, Roland
I suspect the problem lies in the import routine as suggested in my
earlier post that it was suspect. But, you're experiment narrows it
down to the import routine. Please email Dennis and I will contact him
as well...Tnx for sharing your results Roland. Best 73 De N3MX...
-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Roland Guidry
Sent: Saturday, April 20, 2002 10:30 AM
To: [email protected]
Subject: Re: [Logic] Error in Logic 6.0
I went into my list table and deleted the 1010# list. I then imported a
older list from March 2002. Doing this,did not cure the problem.
Cleaning
indexes and updating awards did not help. I did get an error when trying
to
import the 1010.txt file.
"prg12e.err [Read Only]" -
#include 'pda.h'
Error in line 3: File does not exist.
When I ignore the error, it loads data.
Does anyone have any suggestions.
Roland
----- Original Message -----
From: "Stephen J. Schrack" <[email protected]>
To: <[email protected]>
Sent: Saturday, April 20, 2002 8:08 AM
Subject: RE: [Logic] Error in Logic 6.0
> I am experiencing a similar problem, but not quite the same. Mine only
> happens when the 1010 number is a high number. In other words, The
1010
> automatic lookup (or manual) works fine until the 1010 number happens
to
> be one of the higher numbers (60,000 or higher). Then I get the error
> message described below. Sometimes I can recover from that though. I
> suspect it is a corruption of the 1010 list and was going to wait and
> see if the next 1010.txt has the same issue. Perhaps the corruption
> takes place during import? My platform is WinXP Professional 384MB RAM
> on a 1ghz workstation.
>> Best 73 de N3MX...STEVE
>> -----Original Message-----
> From: [email protected] [mailto:[email protected]]
> On Behalf Of Roland Guidry
> Sent: Saturday, April 20, 2002 8:39 AM
> To: [email protected]
> Subject: [Logic] Error in Logic 6.0
>> I am have difficulty with this new program, Logic 6.0 Build 6.0.104.
> When my
> cursor passes over the userfield 1010#, I get an error as shown with
the
> attached gif pic. When I chose "no" the program exits and when
> restarted, I
> have to perform a clean then restart.
>> Sometime I get an error message that says "Invalid Subscript
Reference"
> Cancel or Ignore. If I "Ignore" program continues to run, if I cancel
I
> get
> other errors reported.
>> The file I downloaded for 1010#'s came from Win1010 using their
1010.txt
> file. I do not have this problem with Logic 5.
>> Has anyone encountered this same problem. I email [email protected] on
> 4/18,
> no response to date.
>> Roland, WA5CHX
>>> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic
>>>> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic
>
_______________________________________________
LOGic mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/logic