[Kenwood] TS-440SAT no RF out ?

Sat Jan 28 20:41:41 EST 2006

Is there audio to the rig from the PC?
Mini-plug to the PC in the correct socket? Easy to hit the wrong spigot 
when working backwards in the dark.
Soundcard set up to provide audio output (not muted?). If you run the PC 
audio out to amplified speakers you should hear the PSK warbling.
The Rascal I used with an IC746 (I know, wrong group!) would key the 
radio TX on/off via a com port line so VOX may not be needed.
Can't think of much else except signal tracing.
There are good PSK and MTTY groups that may be more support.
Pat
wa4tuk
Lester Ostrick wrote:
> I hope one of you has had this problem so I can get
> past it.
>> I have a TS-440SAT that is connected to a RASCAL GLX
> via a KW4013 cable [All from Buxcomm.com]. When using
> Digipan [in USB] and I tune or call CQ, the rig says
> it is transmitting but no RF. The same action when
> using Hamscope, Winwarbler etc.. B U T if I set the
> rig to CW I will get RF out at the appropiate power
> asked for ? If I use Hamscope in the CW Mode all
> works well. Yes the rig is always set at Vox on/CW
> semi. If set to VOX off the rig indicates RF out but
> none is even in CW? ?
>> The rig has been to Kenwood Service in VA for
> alignment and a check but reals faults found not too
> long ago.
>> Any body know of some button/switch or prayer that
> needs to be done or said ?
>> 73 de Les, K2TGW
>>> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around 
> http://mail.yahoo.com 
> ______________________________________________________________
> Kenwood mailing list
> Home: http://mailman.qth.net/mailman/listinfo/kenwood
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:Kenwood at mailman.qth.net
>