[Kenwood] TL-922A Plate current
Dave
[email protected]
2002年6月24日 10:09:32 +0000
Jim
The TL-922 does not draw any plate current UNTIL the PTT line is activated
(i.e. grounded...usually by the transceiver driving it .....in your case by
the TS-570)
Dave
At 09:36 PM 6/23/02 -0500, James Barham wrote:
>I recently purchased a 922 to go with my 570. I hooked it up for the first
>time yesterday.
>>According to the manual it should show 100ma on CW and 200ma on the plate
>current in the operate position. I never saw the needle move off of zero
>when swithing between standby and operate..
>> Should you see any plate current if the 570 is not connected to the 922? In
>other words, does the 570 have to be connected via the 7-pin remote before
>you see any plate current?
>>And does menu 39 on the 570 have anything to do with the plate current or is
>it just a relay?
>>I ordered the remote 7 pin cable from Kenwood and the only leads it has are
>pin 4 (relay) and pin 6 (ALC).
>>Thanks,
>>James Barham KC5DSP
>EM-22
>>>- - -
>>Your moderator for this list is:
>Larry Wilson KE1HZ [email protected]
>>_______________________________________________
>Kenwood mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/kenwood
Dave
NR1DX
[email protected]
"A man who picks a cat up by the tail learns a lesson he can learn no other
way" .... Mark Twain