OK Now with the update it works fine. Thanks . Mike -----Original Message----- From: dxbase-bounces at mailman.qth.net [mailto:dxbase-bounces at mailman.qth.net] On Behalf Of Dr. Michael Hunter Sent: Wednesday, January 31, 2007 8:50 PM To: dxbase at mailman.qth.net Subject: RE: [Dxbase] PSK 1.00 Works fine when I use Digipan. Have it set to BPSK. Will upgrade to 2.10 and see if it will make a difference but not sure why it would. -----Original Message----- From: Sanford Ardern [mailto:w4dup at frontiernet.net] Sent: Wednesday, January 31, 2007 8:39 PM To: Dr. Michael Hunter Subject: Re: [Dxbase] PSK 1.00 Hi Mike Do you have your mode set to BPSK ? QPSK or PSK 63 will give you gibberish if you're trying to copy BPSK or PSK31 - (think they are the same thing). Sandy W4DUP ----- Original Message ----- From: "Dr. Michael Hunter" <drmike at infohiwy.net> To: <dxbase at mailman.qth.net> Sent: Wednesday, January 31, 2007 6:51 PM Subject: [Dxbase] PSK 1.00 > Having a problem with the module DxBase PSK 1.00 when trying to copy PSK. > Program works fine but the copy is a mixture of letters and symbols. Using > new Micro Keyer with Dxbase but when I use another program such as > Digipan, > the program works fine. Not much in the Help section. Any suggestions ? >>>> Mike >> K5HDU >> ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Dxbase at mailman.qth.net > ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Dxbase at mailman.qth.net