[DXBase] Com Port problems

2003年4月27日 16:07:04 -0700

I recently upgraded from 2002 to 2004. The rotor control works fine in 
2002. When I attempt to rotate the ant in 2004, the program locks up. I've 
double/triple checked the setting and they are exactly the same as in 2002. 
I have been using com4. I tried writelog using the same com port for rotor 
control and it works fine.
I tried moving the rotor control to com3..The same problem, it works fine 
in 2002 and not in 2004 everything locks up. I have two makes of rotors one 
is M2 the other is Yaesu 1000sdx. I have the same problems regardless of 
which rotor I attempt to use. Both of them work in 2002, none of them work 
in2004 in com4 or com3.
I did and redid the DXB drive setup..no luck. When the program locksup I 
have to do the Cntrl, Alt, del and get the "DXbase not responding" message.
Anyone have some ideas or suggestions about this problem.
Len, K6ANP 