A count-controlled loop must possess three elements: 1. 4 It must initialize a control variable to a starting value. It must test the control variable by comparing it to a maximum value. When the control variable reaches its maximum value, the loop terminates. It must update the control variable during each iteration. This is usually done by incrementing the variable.

Problem Statement for High and Low Design a program that lets the user enter a series of numbers. The user should enter -99 to signal the end of the series. After all the numbers have been entered, the program should display the highest and lowest number in the series. Part 1. Understand the Problem The program will use a while loop to get the numbers from the user. It is not necessary for the individual numbers to be saved;each number can be evaluated as it is read in. To find the highest and lowest number in the series, use two variables. The variables are initialized by getting the first number from the user and assigning it to both the highest and lowest variables. The assumption is, that if there is only one number in the series it is both the highest and lowest numbers. Inside the loop, each number should be compared to the value stored in the highest variable and its value should replace the value in highest variable if it is greater than the number already there. The same can...

In For loop for (statement 1; statement 2; statement 3) { // code block to be executed } The first statement is executed ?! One Time Two Times Every Time Not executed

using R language solve the following question

Design the logic for a program either by pseudocode or flowchart that allows the user to enter a maximum of 10 numbers. If the use enters a -1 the input loop stops early. The value -1 is not data but a quit(sentinel) flag value that is not entered into the array. Then, the program displays the count of the numbers entered and numeric average of the numbers (not including the -1 of course). After display the average of all the entered numbers, the program will then display each number and its difference from that average.

What does the Pretest loop really involve?

Can this be completed using a while loop at least once or twice

2. Use nested For-loop or While-loop to produce "SIFIR 12". 1 x 1 = 1 1 x 2 = .. ==== ==== ==== = 2 x 1 = 2 2 x 2 =わ 4 =わ=わ=わ=わ=わ=わ=わ=わ=わ =わ=わ=わ=わ 1 x 12 = 12 12 x 12 = 144

Write code that uses a while loop to display the powers of 2 exactly as shown below: 1248163264128

PROGRAMMING LANGUAGE: C++ALSO PASTE SCREENSHOTS OF OUTPUTS Write a program that takes +,-,*, and / operators and performs the required operation. the program will continue to execute until ESC key is pressed. Also, the usage of post-test loop and switch statement is mandatory.

in phython langage Write a while loop that will print all the numbers between 200 and 300 (200 and 300 included) that are divisible by 3 but not divisible by 6. Your output should include the following numbers: 201 207 213 219 225 231 237 243 249 255 261 267 273 279 285 291 297

C++

What will be the final value of EAX in this example? mov eax, 0 mov ecx, 10 L1: mov eax, 3 mov ecx, 5 L2: add eax, 5 loop L2 loop L1 (ii) Write a program that calculates the following expression, using registers: A = (A + B) − (C + D) (iii) Write a program that uses a loop to copy all the elements from an unsigned Word array into an unsigned doubleword array. (iv) Write a program that displays a string in all possible combinations of foreground and background colors (16 x 16 =256). The colors are numbered from 0 to 15, so you can use a nested loop to generate all possible combinations. Also use a delay of 1s in each foreground color change.