-
-
Notifications
You must be signed in to change notification settings - Fork 278
-
I needed somewhere to hold my Turing screen that was a bit more stable than my folding holder that came with the device. I created a model for a horizontal frame for the 3.5" Turing screen that slides in from the top. Working pretty well so far. I would create one of the other sizes, but unfortunately I don't have any examples to measure, etc.
If you are interested in 3D printing it (or having a service print it for you), you can find the model at Thingiverse
Beta Was this translation helpful? Give feedback.
All reactions
-
❤️ 2
Replies: 4 comments 2 replies
-
WOWW Niceee
Beta Was this translation helpful? Give feedback.
All reactions
-
Thanks for sharing! ❤️ I will pin this discussion
Beta Was this translation helpful? Give feedback.
All reactions
-
I just purchased a 5" model today, so should have that model to create a frame for. Once I get that done, I will edit the top to add a link to that.
Beta Was this translation helpful? Give feedback.
All reactions
-
Thank you so much for sharing
here is my 3d print
20240310_230617
Beta Was this translation helpful? Give feedback.
All reactions
-
❤️ 1
-
I love it! Glad it worked for you!
Beta Was this translation helpful? Give feedback.
All reactions
-
❤️ 1
-
I updated the Thingiverse link to include a 5" version and a new 3.5" version of the frame. Both new models have thin left sides. The reason is that having a USB-C cable jutting out the side is pretty obnoxious, so I purchased a right angle USB adapter that would send the cable to the back. Unfortunately with the original model, the frame was too thick to allow the right angle connector, so I flattened down that side.
Enjoy!
Beta Was this translation helpful? Give feedback.
All reactions
-
❤️ 1