If you will be distributing your project to a system that will build
your product but it may not be pre-installed with AutoOpts, you may
wish to incorporate the sources for libopts in your project.
To do this, I recommend reading the tear-off libopts library
‘README’ that you can find in the ‘pkg/libopts’ directory.
You can also examine an example package (blocksort) that incorporates
this tear off library in the autogen distribution directory. There is
also a web page that describes what you need to do:
Alternatively, you can pull the libopts library sources into
a build directory and build it for installation along with your package.
This can be done approximately as follows:
tar -xzvf `autoopts-config libsrc` cd libopts-* ./bootstrap configure make make install
That will install the library, but not the headers or anything else.
This document was generated by Bruce Korb on August 21, 2015 using texi2html 1.82.