The nominal frequency ranges for VLBA receiver systems are shown in Table 3. Actual frequency ranges are broader; consult the measurements reported by Hronek & Walker (1996) for details. Updates on frequency-dependent performance across VLBA bands is available at http://www.vlba.nrao.edu/cgi-bin/wbd_dir.pl. These actual ranges may be especially important for avoiding radio frequency interference (RFI), and for programs involving extragalactic spectral lines, rotation measures (Cotton 1995b; Kemball 1999), and multi-frequency synthesis (Conway & Sault 1995; Sault & Conway 1999).
Also shown in Table 3 are parameters characterizing the performance of a typical VLBA station for the various frequency bands. Columns [3] and [5] give typical VLBA system-equivalent-flux-density (SEFD) values at zenith and opacity-corrected peak gains, respectively. These are means over measurements in both polarization at all ten antennas, at the frequencies in column [4].
The typical zenith SEFD can be combined with the aggregate recorded data rate and appropriate integration times to estimate the root-mean-square (RMS) noise level on a single VLBA baseline ($\Delta S$; see Equation 3 in Section 9), and in a VLBA image ( $\Delta I_{\rm m}$; Equation 4 in Section 10). Characteristic values tabulated in columns [6] and [7] are computed assuming, for most cases, the VLBA's current 512-Mbps standard recording rate for continuum observations; a typical fringe-fit interval of 2 minutes; and a total on-source integration time of 8 hours. Exceptions, indicated in the table notes, apply to the fringe-fit intervals at the lowest and highest frequency bands, where shorter intervals are often required; for the recording rate limits imposed by the available RF bandwidth at the lowest frequency bands; and for most parameters at the extreme 3-mm band. Performance may be worse than the tabulated estimates on some baselines due to poor primary or subreflector surfaces or poor atmospheric conditions.
The 3 mm band extends beyond the design specification for the VLBA antenna, and is challenging for the panel-setting accuracy of the primary reflectors, the figure of the subreflectors, and the pointing of the antennas. In addition, performance in this band is highly dependent on weather conditions. Table 4 gives the approximate current performance at 86 GHz for each antenna, as well as the RMS noise in 30 seconds (at 512 Mbps) on a baseline to LA, which is one of the most sensitive 3 mm antennas.
