[LOGic] Logic 8 and Microham Interfaces

Mon Feb 11 12:06:31 EST 2008

Mel
Interface= Microham USB II
Version : USB device Router 5.1.1 - the latest version available at 
Microham website
Radio= Icom Pro III, Ci-V baud rate 19200, CI-V address 6Eh, Ci-V 
transceive On, Ci-V transceive with IC-731 off
Microham USB device router Set up:
Radio Com1, CW Com5 DTR, PTT Com5 RTS, SQL none
This setup works flawlessly with over a dozen programs I have tried in 
the last 2 years.
Logic 8 goes into transmit when I load the program. Also goes into 
transmit when I access and exit the Rig setup menu. Also goes into 
transmit when I access certain other
menus like Utilitys. Only way to get it out of transmit is to remove 
the interface USB plug and re-insert. In Logic 8 I have radio1 setup as 
Icom all, com1, 19200 2 stop bits Addr 6Eh, DTR and RTS not checked.
I dont have the CW keying setup in LOgic right now. Logic sends very 
poor CW, it stutters and sometimes shortens dits or dahs. I been using 
Mixw to send CW , since it sends perfectly. Mixw 2 uses the Com 3 port 
and is not setup for the rig control. I have tried running Logic 8 by 
itself thinking maybe MIXW was interfering but this is not the case.
I have tried other different setups both in Logic and the Device router 
with same results.
Thanks
Stan K9IUQ
Mel Martin wrote:
> Stan... it is good... but a little intermittent at times.
>> What's up with your Microham Interface? I use the Microkeyer with my 
> Icom 781 and 749Pro and works like a charm...
>> Which one are you using?
> How's it configured? PTT lines etc...
> Have you loaded the latest firmware?
>> I can see if it's comparable to my set-up here
>> Mel...
>> Stan wrote: