[LOGic] NIST Time Server Access

Thu Nov 8 11:38:57 EST 2007

I use a DI-524 but only use it as an access point... It doesn't connect to
the WAN...
Make sure you enable UDP port 123 for all IP addresses which is used by the
NTP protocol.
On mine, the only ports pre-defined are:
20,21 (FTP)
80 (HTTP)
443 (HTTPS)
53 (DNS)
25 (SMTP)
110 (POP3)
23 (Telnet)
You may have to add a line for UDP port 123 and enable it.
-----Original Message-----
From: logic-bounces at mailman.qth.net [mailto:logic-bounces at mailman.qth.net]
On Behalf Of R Johnson
Sent: November 8, 2007 11:10
To: logic at mailman.qth.net
Cc: Dennis
Subject: [LOGic] NIST Time Server Access
Hi:
Since I have added a wireless router to my setup, I have been unable to set
my time.
One computer is connected to the router with CAT-5 cable and works fine. The
other computer is connected via a wireless link and gives me an error
message "Not Connected to the Internet" when I try to set the time.
All other Internet access tools such as Updating Lists work fine, so I know
I'm connected.
Has anyone else experienced this problem and how did you solve it ?
I'm using LOGic 8.0.78 and D-Link DI-524 Router.
TIA
Bob,K1VU 
_______________________________________________
LOGic mailing list
LOGic at mailman.qth.net http://mailman.qth.net/mailman/listinfo/logic