[Logic] Spot Log

2004年1月19日 07:30:48 -0600

Hi Julio,
Sure thing -- In order for Logic to properly spot the bands, modes, and 
awards you are interested in seeing on the Spot Log you first have to go 
into Tools/Setup/Bands and configure each band segment of each band for 
what you want to see. In other words, for every band, or segment of a 
band, put in the frequencies and modes that you want the Spot Log to 
report. Then look at the key on the right side of the screen to 
determine for which awards you want reports, such as DXCC, CQZ, etc., 
and either input or remove the proper numbers in each box according to 
what you want the Spot Log to report. Be sure you check the box that 
says Process spots for this band.
 This all takes a bit of time and it is easy to get confused (like I 
did, hi) so it is best to also open the Browse window that corresponds 
to the report. If it is is not open just click the icon that is second 
from last on the lower right corner of the Band table screen.
When you are finished close the Band table and it will prompt you to do 
and Awards Update. This must be done.
Good luck.
-- 
73,
Chris, AC�M
Julio Peralta wrote:
> Chris I don't think I understand about Set Modes. Can you give me a little
> more info.
>> Julio, W4HY