[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]
Did you check the switch to make sure the vlan is being created via GRVP ? If the switch does not support it, you may have to create the VLAN on the switch manually and trunk the ports both to the firewall and the access point. -John Kreno On Thu, Aug 16, 2012 at 12:05 AM, Drew Lehman <dlehman@digitatech.com> wrote: > Ok, I'm at my wits end. I'm hoping someone here has some VLAN experience. > I have client that needs to have a wireless guest SSID setup. The WAP has > the ability to attach an SSID to a VLAN ID. I have a main SSID on VLAN 1 > and a guest on VLAN 100. I have a switch capable of layer 3 switching (HP > Procurve 2910al) and an open source firewall, pfsense, that understands > VLANs. I created a new VLAN/adapter on the pfsense firewall and enabled > GVRP on the switch. I enabled DHCP on the guest VLAN (100), but I can't > seem to get an address on the guest VLAN. Anyone seen anything similar to > this? > ___________________________________________________________________________ > Philadelphia Linux Users Group -- http://www.phillylinux.org > Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce > General Discussion -- http://lists.phillylinux.org/mailman/listinfo/plug -- John Kreno "Those who would sacrifice essential liberties for a little temporary safety deserve neither liberty nor safety." - Ben Franklin ___________________________________________________________________________ Philadelphia Linux Users Group -- http://www.phillylinux.org Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce General Discussion -- http://lists.phillylinux.org/mailman/listinfo/plug