[PLUG] aacraid in 64-bit PCI mode problems

"Tim Wesemann" <timuel@voicenet.com> · 2005年2月21日 19:31:50 -0500

I'm having trouble getting my Adaptec 2200S card running in 64 bit mode 
using stock aacraid from 2.6.9 (also tried 2.4.29) and in a PCI-X slot...
Here's my 'lspci' output:
root@somehost:~# lspci -v -s 02:02.0
02:02.0 RAID bus controller: Adaptec AAC-RAID (rev 01)
 Subsystem: Adaptec 2200S (Vulcan)
 Flags: bus master, 66Mhz, slow devsel, latency 248, IRQ 9
 Memory at f0000000 (32-bit, prefetchable) [size=64M]
 Expansion ROM at <unassigned> [disabled] [size=32K]
 Capabilities: [80] Power Management version 2
(The card can only run at 66Mhz so I'm not worried about that. The card is a 
64-bit PCI card that can run at 66Mhz when in a PCI-X slot)
Is anyone familiar with running any adaptec cards in 64 bit mode under 
linux? I see alot of possibly pertinent 'setpci' options in my pci.h, but 
nothing is jumping out at me... Would anyone like to beat me with the clue 
stick perhaps?
TIA.
--

Tim Wesemann 

___________________________________________________________________________
Philadelphia Linux Users Group -- http://www.phillylinux.org
Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce
General Discussion -- http://lists.phillylinux.org/mailman/listinfo/plug