Primary Attribute
Category:
{{{userDefinedInfo}}}:			{{{userdefinedvalue}}}
Brand: Waveshare

Website
International: {{{website_en}}}
Chinese: {{{website_cn}}}

Onboard Interfaces
CSI

Related Products

Specifications

• Sensor: Sony IMX708
• Resolution: 11.9 million pixels
• Horizontal/vertical: 4608 ×ばつ 2592 pixels
• Sensor size: 7.4mm diagonal
• Pixel size: ×ばつ1.4μm
• The standard model integrates an infrared cut-off filter, while the NoIR model does not have one
• Phase detection autofocus
• Operating temperature: 0°C ~ 50°C

Module Comparison

Standard	NoIR	Wide	Wide NoIR
Focus range	10 cm〜∞	10 cm〜∞	5 cm〜∞	5 cm〜∞
Focal length	4.74 mm	4.74 mm	2.75 mm	2.75 mm
Diagonal viewing angle	75°	75°	120°	120°
Horizontal viewing angle	66°	66°	102°	102°
Vertical viewing angle	41°	41°	67°	67°
Aperture value (F-stop)	F1.8	F1.8	F2.2	F2.2
Infrared sensing	No	Yes	No	Yes

Working with Raspberry Pi

Edit/Configure File

sudo vi /boot/firmware/config.txt

1. Change camera_auto_detect=1 statement to camera_auto_detect=0
2. Add the statement dtoverlay=imx708 at the end of the line, save, and reboot
   Config-imx708.png
   

Check Current Camera Device

rpicam-hello --list-camera 

You can see the camera model and resolution

Available cameras
-----------------
0 : imx708 [4608x2592 10-bit RGGB] (/base/axi/pcie@1000120000/rp1/i2c@80000/imx708@1a)
 Modes: 'SRGGB10_CSI2P' : 1536x864 [120.13 fps - (768, 432)/3072x1728 crop]
 2304x1296 [56.03 fps - (0, 0)/4608x2592 crop]
 4608x2592 [14.35 fps - (0, 0)/4608x2592 crop]

Camera Preview

• Note: The test screen is output to the HDMI screen, so you need to connect the screen to the Raspberry Pi first when testing

rpicam-hello -t 0

Continuous Autofocus and Preview

 rpicam-hello --autofocus-mode continuous -t 0