On Fri, Jul 11, 2025 at 05:35:44PM +0900, Damien Le Moal wrote: > Update ``->error_handler()`` section of the libata documentation file > Documentation/driver-api/libata.rst to remove the reference to the > function ata_do_eh() as that function was removed. The reference to the > function ata_bmdma_drive_eh() is also removed as that function does not > exist at all. And while at it, cleanup the description of the various > reset operations using a bullet list. > > Signed-off-by: Damien Le Moal <dlemoal@xxxxxxxxxx> > --- > Documentation/driver-api/libata.rst | 25 ++++++++++++++++--------- > 1 file changed, 16 insertions(+), 9 deletions(-) > > diff --git a/Documentation/driver-api/libata.rst b/Documentation/driver-api/libata.rst > index 5da27a749246..93d97fe78e3f 100644 > --- a/Documentation/driver-api/libata.rst > +++ b/Documentation/driver-api/libata.rst > @@ -283,18 +283,25 @@ interrupts, start DMA engine, etc. > > ``->error_handler()`` is a driver's hook into probe, hotplug, and recovery > and other exceptional conditions. The primary responsibility of an > -implementation is to call :c:func:`ata_do_eh` or :c:func:`ata_bmdma_drive_eh` > -with a set of EH hooks as arguments: > +implementation is to call :c:func:`ata_std_error_handler`. > > -'prereset' hook (may be NULL) is called during an EH reset, before any > -other actions are taken. > +:c:func:`ata_std_error_handler` will perform a standard error handling sequence > +to resurect failed devices, detach lost devices and add new devices (if any). > +This function will call the various reset operations for a port, as needed. > +These operations are as follows. > > -'postreset' hook (may be NULL) is called after the EH reset is > -performed. Based on existing conditions, severity of the problem, and > -hardware capabilities, > +* The 'prereset' operation (which may be NULL) is called during an EH reset, > + before any other action is taken. > > -Either 'softreset' (may be NULL) or 'hardreset' (may be NULL) will be > -called to perform the low-level EH reset. > +* The 'postreset' hook (which may be NULL) is called after the EH reset is > + performed. Based on existing conditions, severity of the problem, and hardware > + capabilities, > + > +* Either the 'softreset' operation or the 'hardreset' operation will be called > + to perform the low-level EH reset. If both operations are defined, > + 'hardreset' is preferred and used. If both are not defined, no low-level reset > + is performed and EH assumes that an ATA class device is connected through the > + link. > > :: > > -- > 2.50.1 > Reviewed-by: Niklas Cassel <cassel@xxxxxxxxxx>