Bond
The Bond integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] allows you to control appliances through your Bond Bridge. Duplicates your RF remote control.
Supported devices (see Requirements section below):
- Ceiling fans
- Shades
- Fireplaces
Tested Bond devices
The following devices have been tested with Home Assistant and confirmed to be working:
- Bond Bridge v1 (snowbird)
- Bond Bridge v2 (zermatt)
- Bond Bridge Pro (zermatt-pro)
- Smart By Bond Fans (breck)
Prerequisites
To use Bond controlled devices in your installation, add your Bond hub host and access token from the integrations page. Instructions for how to obtain an access token can be found on the Bond Local API documentation, which includes a section for how to obtain the IP address of the device which you will need to obtain the access token.
Configuration
To add the Bond hub to your Home Assistant instance, use this My button:
Bond can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.
If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:
-
Browse to your Home Assistant instance.
-
Go to
Settings > Devices & services . -
In the bottom right corner, select the
Add Integration button. -
From the list, select Bond.
-
Follow the instructions on screen to complete the setup.
Requirements
This integration supports Bond bridges with firmware v2.10.x and up. Bond bridges with firmware v2.9.x and lower will not work correctly. Please upgrade your firmware from Bond app before adding this integration.
BPUP support (Push updates)
Firmware version 2.10.8 or newer is required for push updates. The integration will fallback to polling for 2.10.x versions lower than .8
List of actions
The Bond integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] provides the following actions. Each link below opens a dedicated page with examples, parameters, and a step-by-step UI walkthrough.
-
Set fan speed tracked state (
bond.set_fan_speed_tracked_state) Updates the speed Home Assistant believes a Bond fan is running at. -
Set light brightness tracked state (
bond.set_light_brightness_tracked_state) Updates the brightness Home Assistant believes a Bond light is set to. -
Set light power tracked state (
bond.set_light_power_tracked_state) Updates the power state Home Assistant believes a Bond light is in. -
Set switch power tracked state (
bond.set_switch_power_tracked_state) Updates the power state Home Assistant believes a Bond switch is in.
For an overview of every action across all integrations, see the actions reference.