-
-
Notifications
You must be signed in to change notification settings - Fork 7k
Open
@DanielHaltiner
Description
Arduino IDE Version: 1.8.15
Arduino Hardware: Arduino Nano Every
If you write "digitalWrite (X, HIGH) to a Pin, which has accidentaly defined as an input the processor will set the output, but only a low current commes from this "Fake Output".
It would be very helpfull, if the IDE Software would give a Warning/Input, that in the code is a "digitalWrite" which writes to an Input...
(By defining the analog Inputs I defined the Digital 6 Output further below in the VoidSetup acidentaly again as an Input. This creates an Output half alive... Or I was to dumb to make right code)