-
Notifications
You must be signed in to change notification settings - Fork 12
Unsuccessful with "OptiCore + LuxCore Lens" tutorial #10
-
TripleLens005.zip
I'm trying to recreate simulation done in this tutorial: https://www.youtube.com/watch?v=3hln88ukiZI&t=615s
Here is the result I am getting:
image
It's a pretty picture, but not quite the symmetrical pattern achieved in the tutorial. Any ideas as to what I may have done wrong?
I remade each lens to ensure there was no error there, but no luck.
Beta Was this translation helpful? Give feedback.
All reactions
By changing setting N1 and N2 = 64 during lens creation, I managed to get this picture:
Looks much better, but I wonder what is the difference that results in this image versus the patterns shown in the image from the tutorial.
Replies: 1 comment 1 reply
-
By changing setting N1 and N2 = 64 during lens creation, I managed to get this picture:
image
Looks much better, but I wonder what is the difference that results in this image versus the patterns shown in the image from the tutorial.
Beta Was this translation helpful? Give feedback.
All reactions
-
I have noticed this kind of behaviour also, but I am unsure of the reason behind it. If you increase N1 or N2 in small steps, there is a sudden jump at some point. I also did not do extensive tests if this depends on other parameters like lens curvature.
Beta Was this translation helpful? Give feedback.