-
-
Notifications
You must be signed in to change notification settings - Fork 12
3MS/guides/notip/ #23
3MS/guides/notip/
All reactions
Replies: 1 comment 1 reply
I'm up and running, but no successful prints; I've much tuning to do. I'm trying to go without tip tuning, but it's looking like I'll have to.
My question today is this: why is my print pausing at the beginning of every print? Clicking resume starts everything up.
The console puts this out:
SET_FILAMENT_SENSOR SENSOR=e0_sensor ENABLE=1
That's all I can think of to report that may be causing it.
All reactions
The 3MS only uses one filament sensor right before the printer's extruder. Do you have a filament sensor other than the one the 3MS uses?
If yes, try disabling the other filament sensors.
If no, increase your 3MS's fsensor_delay setting.
I'm currently working on a method of performing faster and simpler tip shaping that might replace the No Tip Shaping feature. Currently, the results are promising but I need to do more testing before I release it.