DRG H 02 1001

The DRG H 02 1001 was a high-pressure steam locomotive built by the engineering firm of Berliner Maschinenbau (formerly L. Schwarzkopff) to the design of Dr L. Löffler.^[1] The aim was not only to improve fuel economy—the usual reason for adopting high steam pressures—but also to increase the amount of power that could be produced within the German loading gauge.

The H02 1001 locomotive was the only example of the Schwarzkopff-Löffler high-pressure boiler system, a complex technology in which heat was extracted from the firebox by tubes filled with steam rather than boiling water. It was delivered in 1930 to the Deutsche Reichsbahn (DRG). Schwarzkopff guaranteed in the purchase contract a coal saving of 42% over a standard 01 locomotive design, but in the event the DRG never bought the locomotive.

Steam was delivered at no less than 1,750 lbf/in² (123 kgf/cm²; 12.1 MPa) to two very small outside cylinders of 220 mm (8+11⁄16 in) diameter. These were compounded with a single 600 mm (23+5⁄8 in) LP inside cylinder. The wheel arrangement was 4-6-2.

After extensive trials it was found that any increase in efficiency was small compared with the greatly increased maintenance costs. The very complicated H02 1001 was also hopelessly unreliable.

The H02 1001 was retired from active service in 1945, then cut up for scrap.

• List of DRG locomotives and railcars

• "High Pressure Steam Engine Halves Fuel Costs". Popular Mechanics: 593. October 1930.
• Hütter, Ingo (2009). Die Dampflokomotiven der Baureihen 01 bis 45 der DRG, DRB, DB, und DR (in German). Werl: DGEG Medien. p.75. ISBN 978-3-937189-45-1.