Considerations for IPv6 Tunneling Solutions in Small End Sites
draft-chown-v6ops-unmanaged-connectivity-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|---|---|---|
| Author | Tim Chown | |
| Last updated | 2003年10月22日 | |
| RFC stream | (None) | |
| Intended RFC status | (None) | |
| Formats | ||
| Stream | Stream state | (No stream defined) |
| Consensus boilerplate | Unknown | |
| RFC Editor Note | (None) | |
| IESG | IESG state | Expired |
| Telechat date | (None) | |
| Responsible AD | (None) | |
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Tunneling IPv6 packets over the IPv4 Internet played a major role in the early stages of IPv6 deployment. This was useful because in the early days the routers in the internet did not support IPv6. Nowadays, tunneling is used to get across legacy equipment and ISPs that do not support IPv6. Many different tunneling mechanisms have been invented. This document describes the drivers for IPv6 tunneling, the general architectures of existing mechanisms, and a set of desirable properties against which subsequent analysis of the mechanisms may be made. The document is aimed at small end sites that may typically utilise tunneling methods in an early IPv6 deployment.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)