#Update: The arduino works only when I connect 3.3v to reset pin. And I successfully uploaded a sketch but it stops when I disconnect 3.3v and reset.
#Update 2: -- Removed -- #Update 3: Its working perfectly and running smoothly for like 5+ min but the problem starts again

[![enter image description here][1]][1]

_{Note: I was uploading the blink (Example) code, tried with others too...} [1]: https://i.sstatic.net/WjFwR.jpg

Update:

The arduino works only when I connect 3.3v to reset pin. And I successfully uploaded a sketch but it stops when I disconnect 3.3v and reset.

Update 2:

-- Removed --

Update 3:

Its working perfectly and running smoothly for like 5+ min but the problem starts again

enter image description here

_{Note: I was uploading the blink (Example) code, tried with others too...}

#Update: The arduino works only when I connect 3.3v to reset pin. And I successfully uploaded a sketch but it stops when I disconnect 3.3v and reset.

#Update: The arduino works only when I connect 3.3v to reset pin. And I successfully uploaded a sketch but it stops when I disconnect 3.3v and reset.
#Update 2: -- Removed -- #Update 3: Its working perfectly and running smoothly for like 5+ min but the problem starts again

• The pre-uploaded blinking sketch works for a few seconds (like 5 sec and only works when powered after a break) and then it starts to glitch
• The L led stays on after that
• Reset button does nothing (No led blinks or anything)
• Can't upload any sketch
• Programmer is not responding
• RX led blinks during uploading (3 times only)
• USB not recognized when connected

• The pre-uploaded blinking sketch works for a few seconds (like 5 sec and only works when powered after a break) and then it starts to glitch
• The L led stays on or off after that
• Reset button does nothing (No led blinks or anything)
• Can't upload any sketch
• Programmer is not responding
• RX led blinks during uploading (3 times only)
• USB not recognized when connected