Previous: Troubleshooting, Up: Using Flymake [Contents][Index]
This section summarizes customization variables used for the configuration of the Flymake user interface.
flymake-mode-line-lighter ¶ The name of the mode. Defaults to ‘Flymake’.
flymake-mode-line-format ¶ Format to use for the Flymake mode line indicator.
flymake-mode-line-counter-format ¶ mode line construct for formatting Flymake diagnostic counters inside the Flymake mode line indicator.
flymake-no-changes-timeout ¶ If any changes are made to the buffer, syntax check is automatically started after this many seconds, unless the user makes another change, which resets the timer.
flymake-start-on-flymake-mode ¶ A boolean flag indicating whether to start syntax check immediately
after enabling flymake-mode.
flymake-start-on-save-buffer ¶ A boolean flag indicating whether to start syntax check after saving the buffer.
flymake-error ¶ A custom face for highlighting regions for which an error has been reported.
flymake-warning ¶ A custom face for highlighting regions for which a warning has been reported.
flymake-note ¶ A custom face for highlighting regions for which a note has been reported.
flymake-indicator-type ¶ The indicator type which Flymake should use to indicate lines with
errors or warnings.
Depending on your preference, this can either use fringes or
margins for indicating errors. On text terminals, only
margins is available.
flymake-error-bitmap ¶ A bitmap used in the fringe to mark lines for which an error has been reported.
flymake-warning-bitmap ¶ A bitmap used in the fringe to mark lines for which a warning has been reported.
flymake-fringe-indicator-position ¶ Which fringe (if any) should show the warning/error bitmaps.
flymake-margin-indicators-string ¶ Specifies the string and face to use for the margin indicators, for each error type.
flymake-margin-indicator-position ¶ Which margin (if any) should show the warning/error strings.
flymake-autoresize-margins ¶ If non-nil, Flymake will resize the margins when
flymake-mode is turned on or off.
Only relevant if flymake-indicator-type is set to margins.
flymake-wrap-around ¶ If non-nil, moving to errors with flymake-goto-next-error and
flymake-goto-prev-error wraps around buffer boundaries.
flymake-show-diagnostics-at-end-of-line ¶ If non-nil, show summarized descriptions of diagnostics at the
end of the line. Depending on your preference, this can either be
distracting and easily confused with actual code, or a significant early
aid that relieves you from moving around or reaching for the mouse to
consult an error message. This value may also be set to fancy,
which will attempt to layout diagnostics below the affected line using
unicode graphics to point to diagnostic locus.
flymake-diagnostic-format-alist ¶ Control which parts of a diagnostic to show in various situations.
flymake-error-eol ¶ A custom face for summarizing diagnostic error messages.
flymake-warning-eol ¶ A custom face for summarizing diagnostic warning messages.
flymake-note-eol ¶ A custom face for summarizing diagnostic notes.
Previous: Troubleshooting, Up: Using Flymake [Contents][Index]