Hi,
You should be able to use the following CLI command to link a controller to your pool:
xe pool-set-vswitch-controller address=<address_of_controller>
Cheers,
Rob
From:
xen-users-bounces@xxxxxxxxxxxxxxxxxxx
[mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Alexey
Larkov
Sent: 15 August 2010 09:06
To: xen-users@xxxxxxxxxxxxxxxxxxx
Subject: [Xen-users] [XCP] openvswitch controller using
I'm using XCP 0.5.0 version.
In the same host in debian VM I installed SNAC http://www.openflowswitch.org/wp/snac/ 1.0 as openflow controller.
1. Is it possible to setup openvswitch controller from xsconsole?
Controller (config) xxx.xxx.xxx.xxx - display <SNAC ip address>
Controller (in-use) <None> - always display "None"
2. I tried to use folowing commands:
ovs-vsctl set-controller xenbr0 tcp:<SNAC ip address>
For a few minutes everything works good and I can manage switch from <SNAC ip address>, but than connection to host has broken suddenly.
Connection to host's VM's may works longer, but usually lost also or a bit later.
Connection immediately restored after command: ovs-vsctl del-controller xenbr0.
In SNAC contoller switch looks good, no denied packets.
I can't find any criminal in log files.
I'd be appreciate for any help and advice how to dig the problem.
--
Kind regards,
Larkov Alexey
_______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Xen-users] migration, shared storage and fencing , David Heidt |
|---|---|
| Next by Date: | [Xen-users] Xen Network Configuration Problem , 张欣接 |
| Previous by Thread: | [Xen-users] [XCP] openvswitch controller using , Alexey Larkov |
| Next by Thread: | RE: [Xen-users] [XCP] openvswitch controller using , Rob Hoes |
| Indexes: | [Date] [Thread] [Top] [All Lists] |