My domU cannot communicate with anything other than the dom0. The dom0
has no problems with any kind of communications.
I have seen some posts that imply that xenbr0 should have an IP address,
however, I cannot verify that.
What works:
Ping Dom0->DomU
Ping DomU->Dom0
SSH, etc Dom0->DomU
SSH, etc DomU->Dom0
Anything Dom0->(internet, intranet)
What doesn't Work:
Anything DomU->(internet, intranet, including gateway)
Some Information:
Dom0 IP: 10.0.0.12
DomU IP: 10.0.0.13
Gateway IP: 10.0.0.1
Below are some config and status snapshots:
[root@xen ~]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:1D:09:29:80:41 
 inet addr:10.0.0.12 Bcast:10.0.0.255 Mask:255.255.255.0
 inet6 addr: fe80::21d:9ff:fe29:8041/64 Scope:Link
 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
 RX packets:694 errors:0 dropped:0 overruns:0 frame:0
 TX packets:86 errors:0 dropped:0 overruns:0 carrier:0
 collisions:0 txqueuelen:0 
 RX bytes:65309 (63.7 KiB) TX bytes:19087 (18.6 KiB)
lo Link encap:Local Loopback 
 inet addr:127.0.0.1 Mask:255.0.0.0
 inet6 addr: ::1/128 Scope:Host
 UP LOOPBACK RUNNING MTU:16436 Metric:1
 RX packets:2211 errors:0 dropped:0 overruns:0 frame:0
 TX packets:2211 errors:0 dropped:0 overruns:0 carrier:0
 collisions:0 txqueuelen:0 
 RX bytes:2625224 (2.5 MiB) TX bytes:2625224 (2.5 MiB)
peth0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF 
 inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link
 UP BROADCAST RUNNING NOARP MTU:1500 Metric:1
 RX packets:774 errors:0 dropped:0 overruns:0 frame:0
 TX packets:206 errors:0 dropped:0 overruns:0 carrier:0
 collisions:0 txqueuelen:1000 
 RX bytes:73258 (71.5 KiB) TX bytes:26937 (26.3 KiB)
 Interrupt:16 Memory:f8000000-f8012100 
vif0.0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF 
 inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link
 UP BROADCAST RUNNING NOARP MTU:1500 Metric:1
 RX packets:98 errors:0 dropped:0 overruns:0 frame:0
 TX packets:700 errors:0 dropped:0 overruns:0 carrier:0
 collisions:0 txqueuelen:0 
 RX bytes:21671 (21.1 KiB) TX bytes:65669 (64.1 KiB)
vif1.0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF 
 inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link
 UP BROADCAST RUNNING NOARP MTU:1500 Metric:1
 RX packets:129 errors:0 dropped:0 overruns:0 frame:0
 TX packets:532 errors:0 dropped:0 overruns:0 carrier:0
 collisions:0 txqueuelen:32 
 RX bytes:3612 (3.5 KiB) TX bytes:45994 (44.9 KiB)
xenbr0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF 
 inet6 addr: fe80::200:ff:fe00:0/64 Scope:Link
 UP BROADCAST RUNNING NOARP MTU:1500 Metric:1
 RX packets:650 errors:0 dropped:0 overruns:0 frame:0
 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
 collisions:0 txqueuelen:0 
 RX bytes:52872 (51.6 KiB) TX bytes:0 (0.0 b)
[root@xen ~]# brctl show
bridge name bridge id STP enabled interfaces
xenbr0 8000.feffffffffff no vif1.0
 peth0
 vif0.0
[root@xen ~]# iptables -L
Chain INPUT (policy ACCEPT)
target prot opt source destination 
Chain FORWARD (policy ACCEPT)
target prot opt source destination 
ACCEPT all -- anywhere anywhere PHYSDEV
match --physdev-in vif1.0 
Chain OUTPUT (policy ACCEPT)
target prot opt source destination 
[root@xen ~]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
10.0.0.0 * 255.255.255.0 U 0 0 0
eth0
169.254.0.0 * 255.255.0.0 U 0 0 0
eth0
default 10.0.0.1 0.0.0.0 UG 0 0 0
eth0
from everything I know, this looks like it should work.
Any ideas?
Thanks,
Stuart
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users