NEW! RCL-1
RS232 Level Converter in a DB9 backshell
See:
Questions:
-
TakeThisOuTdimithri~NOSPAM~ at KILLspamgmail.com
asks:
Hello, I am looking to connect a MAX522 DAC through the PIC18F452's SPI interface
and a PCF8575 I/O expander through the I2C interface. However both the SPI
and I2C modules connect to the same pins of PORTC. Anybody knw away around
this? Appreciate it if you cld help...
Regards,
Dimithri
-
hi there!
im using PIC16F877 as microcontroller to interface with the pc side via VB
program, nevertheless the BasicComm i found it here is quite useful. I would
like to know the way on how to send and receive frm the PIC16F877 so that
it'll be a close loop control within the hardware and the pc. thank you
+
-
TakeThisOuTbrentano~NOSPAM~ at KILLspamruhle.com
asks:
I have an application that calls for a 19bit synchronous serial interface:
clock supplied externally @ 1.2MHz. I am trying to use the Advanced USART
in the 18F1320. I am trying to write out three consecutive 8 bit words, I
use a timer to timeout during the middle of the third word to exit (since
I only have 19 clocks not 24). The interface works for a short while but
then gets stuck waiting to transmit the second byte. Does anyone have any
suggestions? Thanks.
+
Archive:
file: /Techref/microchip/serial.htm,
2KB, , updated: 2021年12月13日 19:21, local time: 2025年9月4日 08:41,
©2025 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE.
Questions?<A HREF="http://massmind.org/techref/microchip/serial.htm"> PIC Microcontoller Serial Input / Output Methods</A>
Did you find what you needed?
Welcome to massmind.org!
Welcome to massmind.org!
.