[Yaesu] Yaesu FT-757 GX, and associated items FS

Sat Feb 10 10:18:15 EST 2018

Yaesu FT-757GX, HF Transceiver and Associated Items For Sale.
Also linear amp interface box, hand mic, mic adapter,
programing software/hardware, and manuals For Sale :
.
.
Yaesu FT-757 GX, HF Transceiver:
The Yaesu FT-757GX is an HF transceiver covering 160 to 10
meters with ten memories. The general coverage receiver
tunes from 500 kHz to 30 MHz. Power is 100 watts CW, SSB,
FM and 25 watts AM. The FT-757GX features IF Shift,
Electronic Keyer, Squelch and Noise Blanker.
The top panel has CW adjustments. The rear panel has
numerous input and output jacks. It requires 13.8 VDC
at 19 Amps.
Features:
160-10 meters
IF Shift
Keyer w/Semi/Full Break-in CW
Dual VFOs
Noise Blanker
100 Watts Output
General coverage receive
Speech Compressor
It should be noted that this is not the high quality rigs
I normally sell, but an average transceiver, but the price
reflects this fact. It does have dual VFOs, WARC Bands,
and memories, as well as an internal keyer.
Hand mic, power cord, and paper work included for 250ドル.
.
.
Yaesu XF-8.2M-601 Crystal Filter:
The XF-8.2M-601 is used in the 8.2 MHz IF of many
Yaesu transceivers, including the FT-102, FT-747,
FT-757, FT-767, and possibly the FT-1000 series.
I was told it would work in the FT-1000 but have
not been able to confirm that, so please check
your manual.
The 600 hz bandwidth is ideal for CW, but it is
also great for RTTY and other digital modes,
including FT-8, PSK-31, etc.
This one works fine. It looks fine also, as if
that matters for an internal filter. It is a
"solder in" filter. Only 70ドル.
.
.
Cable for computer control for Yaesu:
This cable was used on a Yaesu FT-757 GX, but I am
fairly certain that it can be used on other Yaesu
radios as well. The radio end has a small 3 pin, in
line, connector, which is of the same type as used
to plug into the various PC boards inside the radio.
The other end is a standard USB connector, which has
a USB to serial converter in the USB plug. To put it
another way, plug the 3 pin end into your radio, and
the other end into a USB connector on your computer,
and you should be good.
This one works fine. Only 20ドル.
.
.
Buy all three of the above items (rig, CW filter, and
computer cable) for 325ドル.
.
.
Yaesu FRB-757 Linear Amp T/R Relay Switch Box:
Many of the modern rigs are not capable of switching
the higher currents and voltages of the transmit
receive relays of some linear amplifiers. This small
box was made by Yaesu to remedy that situation.
Although it was made for the FT-757, it can be used
with almost any rig that needs a heavier relay to
switch the linear amp. It does not even need to be
a Yaesu rig.
This box needs 13 V DC (and has an RCA phono plug
for that purpose), and is connected to the rigs
linear amplifier relay output with another RCA phono
plug. The output of the box has both normally open
and normally closed contacts, both terminated in
RCA phono jacks. Contacts are rated at 600 VA AC,
150 W DC load, and will switch up to 250 volts and
up to 5 amps.
-
This one works fine and looks fine. Only 40ドル.
.
.
Yaesu MH-1 B8, Hand Microphone:
The MH-1 is the standard hand mic used on most
modern Yaesu radios. It has a round 8 pin
connector on it. The mic itself has up, down,
and FST buttons on the top, to permit one to
change the frequency. On the back is a tone
switch to permit one to slightly alter the
frequency response of the mic.
If your Yaesu transceiver uses a round 8 pin
connector, this mic should work for you.
This one works fine, and looks fine as well.
Only 35ドル.
.
.
Microphone adapter:
This adapter will adapt any mic wired with the
Kenwood 4 pin connector, and convert it to a
Yaesu round 8 pin connector.
Works fine; looks fine. 20ドル
.
.
RT Systems ADMS-1802 Software/hardware:
The ADMS-1802 consists of a hardware cable, plus
a software CD, plus instructions to program a Yaesu
FT-1802.
These days the rigs have so many memories plus other
features, that it is almost impossible to program them
manually. The ADMS-1802 takes care of this problem
for the Yaesu FT-1802.
This unit appears that it might be new. Everything is
included -- Software CD, Cable, and instructions. Also
included is the serial number to make the software work.
This retails for 48ドル.95. Buy this one for only 30ドル.
.
.
Original Yaesu Manuals:
These are the manuals only. All are originals, and not copies.
Most are in close to new condition.
FNB-9,10,11,12 Battery packs, 2ドル
FT-720 R, 2 meter mobile, 8ドル
FT-890, HF Transceiver, 15ドル
FT-1802 M, 2 meter mobile, 12ドル
FTH-2005 HT, 5ドル
FTS-8 tone squelch unit, 3ドル
FTS-12 tone squelch unit, 3ドル
MH-1B A2B speaker microphone, 2ドル
SP-101 P, Speaker / Phone patch, 5ドル
VX-1 dual band HT, 10ドル
YC-601 digital readout, 10ドル
These are original Yaesu operating manuals only,
in very nice condition.
.
.
I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
etc.
Just too many to list here. Please e-mail your requests.
.
Prices do not include shipping from Florida.
.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400
.