[Yaesu] FS: Yaesu FT100D-inexpensive

Sat Aug 25 15:40:35 EDT 2007

John,
If I were you, I would remove the lock washers. Perhaps one of your lock
washers was too large and has shorted out a land that was printed close to
one of the mounting pad.
* 73's Jim W5IFP *
> -----Original Message-----
> From: yaesu-bounces at mailman.qth.net
> [mailto:yaesu-bounces at mailman.qth.net]On Behalf Of John Geiger
> Sent: Saturday, August 25, 2007 6:14 PM
> To: forsale-swap at mailman.qth.net; Yaesu at contesting.com;
> yaesu at mailman.qth.net; FT100 at yahoogroups.com; vhf at w6yx.stanford.edu;
> 50mhz at mailman.qth.net
> Subject: [Yaesu] FS: Yaesu FT100D-inexpensive
>>> I have for sale a Yaesu FT100D in very good physical condition, with the
> mic, manual, mobile bracket, power cord, and original box. Now
> here is the
> deal. It was working fine, other than showing the self
> oscillation problem
> on 70cm. I opened it up to add some lock washers to the circuit board
> screws, and after putting it back together and turning it on,
> the receiver
> is very low on SSB/CW. It is putting out full power on transmit, and the
> receive is OK on FM (but with no S meter reading). You can hear a few
> signals on CW/SSB, but it is very reduced from what it should be.
>> Might be an easy fix, I don't know, but I am asking 250ドル shipped
> for this,
> or will trade for an HF or HF/6 rig to keep me on the air.
>> 73s John AA5JG
> (ex: W5TD, NE0P)
> 6M WAS #1275, 6m VUCC #1260
> 2m VUCC #615, Satellite VUCC #129
>