[Yaesu] HELP needed to un-CB a FT-902DM and restore 10M operation
[email protected]
[email protected]
2002年4月03日 21:04:42 -0600
Did you order the xtals from Yaesu or a 3rd party?? Also I would
HIGHLY suggest getting the service manual on the rig and following
the alignment to the T....That should fix your problem (also the
manual may show later mods done at the factory your rig may be
lacking and could use)
Chris
WB5ITT
[email protected] wrote:
>> Bought a nice FT-902DM at a ham fest a year ago that works great, except no
> 10M. ( The rig came with CB xtals in place of the 10M A-B-C-D xtals in
> the Xtal Oscillator and works fine on CB freqs but only allowed me to tune
> a few khz of 10M....to around 28.050. )
> SO, the solution seemed simple enough. I purchased the proper 10M xtals
> and installed them.
> Any suggestions on where I go from here?
>