[LOGic] LOGic 9 and IC-756 PRO3 CIV control ???

Mon May 28 09:14:15 EDT 2012

Hi Bob, I am using a 756 PRO III and a 746 PRO with Logic 9.
The way to make it work is in the rig selection on the radio
page.
Go to Tools/Setup/Misc Rig TNC. Select Radio Interface tab.
For your radio selection make sure you choose
IC775 756 780 rigs will (rigs with main sub instead of a/b vfos.) (Legacy)
On the bottom of that page check poll Icoms and set interval to 2 seconds.
Also of course you must have the baud rate etc. set properly.
Your rig addr for the PRO III is 68E. Let me know if you need any
further help.
 Mike Sanders
 KOAZ
-----Original Message-----
From: logic-bounces at mailman.qth.net
[mailto:logic-bounces at mailman.qth.net]On Behalf Of rjohnson
Sent: Sunday, May 27, 2012 21:33 PM
To: logic at mailman.qth.net
Subject: [LOGic] LOGic 9 and IC-756 PRO3 CIV control ???
Has anyone been able to control A=B and SPLIT on the IC-756 PRO3 with LOGic
9.
I was under the impression when I bought LOGic 9, that this problem was
going to be fixed fixed.
If anyone is using this configuration sucessfully, please let me know how to
set it up !!!
TNX es 73
Bob, K1VU
______________________________________________________________
LOGic mailing list
Home: http://mailman.qth.net/mailman/listinfo/logic
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:LOGic at mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1424 / Virus Database: 2425/5026 - Release Date: 05/27/12