[LOGic] multiple rig interfaces

Sun Jul 29 11:24:04 EDT 2007

I've encountered a similar issue... But I don't believe it was an overflow.
The older Icoms, in any case, will not respond to polls if they are
otherwise "busy" and a Logic eventually times out the frequency/mode
request.
-----Original Message-----
From: logic-bounces at mailman.qth.net [mailto:logic-bounces at mailman.qth.net]
On Behalf Of george
Sent: July 27, 2007 21:53
To: 'LOGic is open to all radio amateurs for discussion of LOGic logging
program'
Subject: [LOGic] multiple rig interfaces
I have an Icom 756 pro3 and an icom 706 attached to a home made ct-17 and I
am able
To poll both radios just fine but if I click on a button to change frequency
on eithier rig it starts to change and if I hold it down to 
Change it faster I get a timeout which requires a rig/rotor reset. Baud rate
is high as it will go at 19200 8N2

Like the buffer gets full and overflows then I get an error.

Both rigs are on one com port with the interface.

Is there a way to ignore the overflow errors
No virus found in this outgoing message.
Checked by AVG Free Edition. 
Version: 7.5.476 / Virus Database: 269.10.22/922 - Release Date: 7/27/2007
6:08 AM

_______________________________________________
LOGic mailing list
LOGic at mailman.qth.net http://mailman.qth.net/mailman/listinfo/logic