[Logic] Logic-7 Frequency Readout

Tue Sep 21 14:30:20 EDT 2004

Since installing Logi-7 about two months ago, I have had trouble with the 
frequency readout tracking the TS850S. The TS850S is always turned on first and 
then Logic-7. Once in a while it will track the TS850S frequency but most 
of the time it will not. When entering a callsign, it will change to the 
current frequency in use and enter it into the log. I have clicked on 
Tools|Reset Radio & Rotor Interfaces (No Results). Clicked on Tools|Setup|Misc Ham 
Setup, Rig, TNC... (The Misc. Setup Screen appears). Clicking on Radio IFC, 
following are the settings:
Radio 1
Driver - Kenwood 850S
Port - Com1
Baud Rate - 4800
Stop Bits - 2
DTR & RTS both checked
Polling Interval - 2.0

I have tried changing the Baud Rate, Stop Bits and Polling Interval all with 
negative results.

Appreciate any corrective suggestions.

73, Dick W7MPZ