[Logic] add space to labels
Julio Peralta
[email protected]
2003年4月21日 22:24:27 -0400
This may not be a printer problem. Check to see that the printing on each
label on the 1st page of labels appears in exactly the same place on the
label if it doesn't the problem is probably that the text is not properly
placed on the label stock you are using. If that is the case maybe Art or
Dennis will be able to help you re-center the text on the label stock. The
problem usually is that the data prints to low on the 1st label. Subsequent
labels print lower until they start printing off the label stock.
Julio, W4HY
----- Original Message -----
From: "Ken Goetz" <[email protected]>
To: <[email protected]>
Sent: Monday, April 21, 2003 9:20 PM
Subject: [Logic] add space to labels
> I am having a slight problem when printing labels. Every 2nd or 3rd sheet
of
> labels will print with part of the info (either QSL or address) a bit too
> high in the label. This causes the writing to be split between 2 labels.
(I
> realize this is a problem with my printer feed). Is there an easy way to
add
> a blank line at the top of each label? While not fixing the printer, this
> would be a "work-around for the problem. I am printing "QSL labels with
> address, three across" and I am using Avery 5160 labels.
>> Thanks,
> Ken N2SQW
>> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic
>